timer is inoperative in synchronous mode.
Range: 0-255 tens of seconds (0-2550 seconds)
Default: 0 (disabled)
S46 - Data Compression Control
S46 controls selection of compression. The following actions are executed for the given values:
Range: 136 or 138
Default: 138
S46=136 Execute error correction protocol with no compression.
S46=138 Execute error correction protocol with compression. (Default.)
S95 - Extended Result Codes Control
A bit set to a 1 in this parameter, in conjunction with the W command, will enable the
corresponding extended result code (see Section 3.5 and Table 3-14).
The +MR, +ER, and +DR settings also control S95 bits 2, 3, and 5, respectively. The more
recent settings of +MR, +ER, and +DR, or host writing of S95 bits 2, 3, and 5, along with the
W command setting, determine the corresponding actual result code reporting (see +MR,
+ER, DR, and W commands).
Default: 0
Bit 0 CONNECT result code indicates DCE speed instead of DTE speed.
Bit 1 Reserved
Bit 2 MCR: XXXX result code (XXXX = modulation) and +MRR: XXXX
result code (XXXX = rate). (See +MR.)
Bit 3 ER:XXXX result code (XXXX = protocol identifier). (See +ER.)
Bit 4 Reserved.
Bit 5 DR result code (XXXX = compression type). (See +DR.)
Bits 6-7 Reserved.
3.5 Result Codes
The modem responds to commands from the DTE and to activity on the line by signaling to
the DTE in the form of result codes. The result codes that the modem can send are described
in Table 3-15.
Two forms of each result code are available: long-form, an English-like "verbose" response,
and short-form, a data-like numeric response (included in parentheses following the longform).
The long-form code is preceded and terminated by the sequence < CR> < LF>. The
short-form is terminated by < CR>, only with no preceding sequence.
If result messages are suppressed, nothing is returned to the DTE. The long-form results codes
can be modified by the OEM through the .INF file.
Table 3-15. Result Code Definitions
Code Message Meaning
+F4 +FCERROR High speed fax data (V.27, V.29, V.33, or V.17) is expected but a V.21 signal is received.
0
OK A command line has been executed.
1 CONNECT For X command values specifying no speed reporting, the modem has connected to the line
and either the line speed is 300 bps and line speed is enabled, or the DTE speed is 300 bps
and DTE speed reporting is enabled.
2 RING An incoming ring signal is detected on the line. What qualifies as a ring signal is determined by
country-dependent parameters, modifiable through ConfigurACE.
When cellular interface is selected, RING indicates that the cellular phone is receiving an
receiving an incoming call.
3 NO CARRIER Sent when attempting to establish a call if:
Ringback is detected and later ceases but no carrier is detected within the period of time
determined by register S7, or
