+PMHT – Modem-on-Hold Timer...........................……….......3-71
+PQC - V.92 Phase 1 and Phase 2 Control ........…….............3-74
+PSS - Use Short Sequence ...............................……….........3-75
+VCID - Caller ID (CID) .....................................……...............3-3
+VRID - Caller ID (CID) .......................................………..........3-4
+WS= – Enable/Disable PDC.............................………............3-83
A
A - Answer.................................................................……….....3-27
AT? - Read Selected S-Parameter ........................………........3-77
AT=x - Write to Selected S-Parameter...................………........3-77
D
D - Dial3-25
E
E - Command Echo................................................………....... 3-12
H
H - Disconnect (Hang-Up) ...................................………......... 3-28
I
I - Request Identification Information .......................……........ 3-7
L
L - Speaker Volume ................................................………..... 3-29
M..
M - Speaker Control ...............................................………...... 3-29
N
N - Automode Enable............................................………........ 3-49
\N - Operating Mode..............................................………........ 3-5
O
O - Return to On-Line Data Mode ..........................………...... 3-28
P
P - Set Pulse Dial Default........................................………...... 3-27
Q
Q - Quiet Results Codes Control ............................………...... 3-12
-QCPC - Force Full Startup Procedure Next Connection…….. 3-76
-QCPS - Enable Quick Connect Profile Save ..............………. 3-76
S
S0 - Number of Rings to Automatic Answer ................………..3-78
S1 - Ring Counter....................................................……….......3-78
S10 - Lost Carrier To Hang Up Delay ......................………......3-81
S11 - DTMF Tone Duration .....................................…………...3-81
S12 - Escape Prompt Delay (EPD) .....................………...........3-81
S18 - Test Timer....................................................…………......3-81
S2 - Escape Character ...........................................………........3-79
S29 - Flash Dial Modifier Time...............................……….........3-81
S3 - Line Termination Character ...........................……….........3-79
S30 - Disconnect Inactivity Timer............................………........3-82
S4 - Response Formatting Character .....................………........3-79
S46 - Data Compression Control ............................………........3-82
S5 - Command Line Editing Character......................………......3-79
S6 - Wait Time for Dial Tone Before Blind Dialing, or After
“W” Dial Modifier............................................……………....3-80
S7 - Wait Time For Carrier After Dial, For Silence, or For Dial
Tone After “W” Dial Modifier ..........................……………...3-80
S8 - Pause Time For Dial Delay .............................………….....3-80
S95 - Extended Result Codes Control ......................………......3-82
Sn - Read/Write S-Parameter ...................................………......3-78
T
T - Set Tone Dial Default ...........................................……….....3-27
V
V - Result Code Form...........................................…………........3-13
W
W - Connect Message Control..............................………..........3-13
X
X - Extended Result Codes ..................................………..........3-14
Z
Z - Reset to Default Configuration.............................………......3-2
