No carrier loss events, 3 carrier rate
renegotiations attempted; 1 carrier retrain
requested; 1 carrier retrain granted
DIAG <2A4D3263 34=7080 35=CB20> Final transmit rate is 28800 bit/s; final receive rate is 52000 bit/s
DIAG <2A4D3263 40=1 41=100> LAPM negotiation completed; frame size = 256
DIAG <2A4D3263 42=0 43=0> No error control timeout or link NAKs
DIAG <2A4D3263 44=1 45=400> V.42bis data compression used; dictionary size = 1024
DIAG <2A4D3263 50=2 51=2> Hardware transmit and receive flow control
DIAG <2A4D3263 52=343CC 54=0> 213964 DTE characters transmitted, w/o underrun
DIAG <2A4D3263 53=7230E6 55=47> 7483622 DTE characters received, 71
characters lost due to receive data overrun
DIAG <2A4D3263 56=29D 58=0001> 597 (decimal) frames transmitted, with 1 frame error
DIAG <2A4D3263 58=2A4B 59=0004> 10827 (decimal) frames received, with 4 frame errors
DIAG <2A4D3263 60=51> Local PC initiated hangup
3.2.10 V.92 +P and –Q Commands
This section describes the +P (PCM DCE) and –Q commands and parameters used to control
the V.92 Mode operation.
+PCW - Call Waiting Enable
This command controls the operation of the modem in the presence of call waiting.
Syntax
+PCW=<value>
Defined Values
<value> Decimal number corresponding to the selected operation.
0 Request modem-on-hold if enabled by +PMH and
collect caller ID information if enabled by +VRID.
Toggle V.24 circuit 125. (Default.)
1 Hang-up.
2 Ignore call waiting.
Result Codes
OK <value> = 0, 1, or 2.
ERROR Otherwise.
Reporting Selected Value(s)
Command: +PCW?
Response: +PCW: <value>
Example: +PCW: 0 For the default setting.
Reporting Supported Range of Parameter Values
Command: +PCW=?
Response: +PCW: (<value> range)
Example: +PCW: (0,1,2)
+PMH - Modem-on-Hold Enable
This command controls the selection of modem-on-hold in the modem. The action of the
modem in response to modem-on-hold events is determined by the state of this command as
well as the state of a negotiated handshake with a V.92-compliant server in V.92 Mode.
Syntax
+PMH=<value>
Defined Values
<value> Decimal number corresponding to the selected operation.
0 Modem-on-hold enabled in V.92 Mode. (Default.)
1 Disabled modem-on-hold.
Result Codes
