Alfa Romeo Tonale, Owner'S Handbook Manual

Page: 111 / 296

109
Changing the system settings
System settings can be changed via the
Alfa Connect system (see "Settings"
> "Safety & Driving Assist" > "Lane
Keeping Assist" supplement on Alfa
Connect system online).
System limited operation warning
30) 31)
If the dedicated message is shown on the
display, a condition limiting the system
operation may have occurred. The
possible reasons of this limitation are
something blocking the camera view or a
fault.
If an obstruction is signalled, clean the
area of the windscreen by the interior
rear-view mirror and check that the
message has disappeared.
Although the car can still be driven in
normal conditions, the system may be
not completely available.
When the conditions limiting the system
functions end, this will go back to normal
and complete operation. Should the
fault persist, contact an Alfa Romeo
Dealership.
No hands on steering wheel detection
If the system detects no hands from
the steering wheel during active system
intervention, the system will produce an
escalation of visual-acoustic warnings,
which will take 15 seconds to invite the
driver to put the hands on the steering
wheel. If you do not put your hands on
the wheel within this time, the system
will disconnect and provide an additional
warning for 5 seconds.
System Fault Message
If the system switches off and a
dedicated message is shown on the
display, it means that there is a fault on
the system.
In this case, it is still possible to drive the
vehicle, but you are advised to contact
an Alfa Romeo Dealership as soon as
possible.
iTPMS (indirect Tyre Pressure
Monitoring System)
66) 67) 68) 69) 70) 71)
The car can be equipped with the iTPMS
(indirect Tyre Pressure Monitoring
System) which monitors the tyre
inflation status.
CORRECT TYRE PRESSURE
If no flat tyres are detected, the outline
of the car will be shown in the dedicated
display screen.
LOW TYRE PRESSURE
The system warns the driver if one or
more tyres are flat by turning on the
symbol on the instrument panel and
showing a warning screen fig. 117on the
display along with an acoustic warning.
This warning is displayed also when
turning the engine off and on again until
the RESET procedure is carried out.
117
9650089
RESET PROCEDURE
The iTPMS needs an initial "self-learning"
phase (with length depending on the
driving style and road conditions: optimal
conditions being driving on a straight
road at 80 km/h for at least 20 minutes)
which starts when the RESET procedure
is carried out manually.
The RESET procedure must be carried
out:
each time tyre pressure is modified
when even only one tyre is changed
when tyres are rotated/inverted
when the space-saver wheel is fitted
Before carrying out the RESET
procedure, inflate the tyres to the rated
pressure values specified in the inflation
pressure table (see the "Wheels" chapter
in the "Technical specifications" section).