Alfa Romeo Tonale, Owner'S Handbook Manual, Page: 180 / 296

STARTING AND DRIVING
178
the presence of adhesives on the
sensors. Therefore, take care not to
place stickers on the sensors
Changing the system settings
System settings can be changed using
the Alfa Connect system (see "Settings"
> "Safety & Driving Assist" > "Park
Sensors Front Volume" supplement on
Alfa Connect system online).
VERSIONS WITH 8 or 12 SENSORS
The parking sensors, located in the front
bumper, fig. 184 and fig. 185 (one on each
side, for the 12-sensor version only) and
rear bumper fig. 186 and fig. 187 (one on
each side, for the 12-sensor version only),
are designed to detect obstacles in the
vicinity of the car. The sensors warn the
driver about the presence of obstacles
with an intermittent acoustic signal and
also with visual indications on the Alfa
Connect display.
184
9650046
185
9650047
186
9650045
187
9650049
Manual system activation/deactivation
188
9650116
To deactivate the system manually,
press the button fig. 188 located on the
central tunnel .
The LED on the button indicates the
system status and is:
off when the system is active
on when the system was manually
deactivated by the user or in a fault or
temporary disable condition
If the button is pressed with a system
failure, the LED flashes for about 5
seconds, then it stays on constantly.
WARNING After switching off the
button, the Park Sensors system
remains in this state until the next time
it is switched on, even after the car has
been switched off and on again. The
deactivation status of the system
is indicated by a message on the
instrument panel display when reverse
gear is engaged.