Alfa Romeo Tonale, Owner'S Handbook Manual

Page: 193 / 296

191
speed limit) and the green circle around
the road sign indicating the speed limit.
198
9650118
The system is deactivated under the
following conditions:
when the Traffic Sign Recognition
system is deactivated
when the Speed Limiter system is
deactivated
when the Traffic Sign Recognition
system shows a new speed limit
when the Traffic Sign Recognition
system shows the end of the speed limit
when the Traffic Sign Recognition
system cannot display any speed limit
EXCEEDING THE PROGRAMMED
SPEED
By fully depressing the accelerator
pedal, the programmed speed can be
exceeded even with the system active
(e.g. in the event of overtaking).
The system is disabled until the speed
drops below the set limit, after which it
activates again automatically.
SETTINGS
System settings can be changed using
the Alfa Connect system (see "Settings"
> "Safety & Driving Assist" > "Intelligent
Speed Assist" on the Alfa Connect
system online supplement).
REAR CAMERA (PARKVIEW®
REAR BACKUP CAMERA)
(where provided)
166) 74)
The camera is located on the boot
tailgate fig. 199.
199
9650198
Camera activation/deactivation
Whenever reverse gear is engaged, the
Alfa Connect system display, fig. 200, will
show the area around the car, as seen by
the Rear View Camera.
200
9650197
The images are shown on the display
together with a warning message.
With the "Camera Delay” option active,
when engaging the reverse gear, the
image from the camera will continue to
be displayed for up to 10 seconds after
reverse is disengaged, unless car speed
is higher than 13 km/h, or:
check that the gear lever is in the “P”
position
the ignition device is in the STOP
position
When the shift lever is no longer in the
“R” position, a button for deactivating the
display of the image from the camera
appears on the Alfa Connect system
display along with the images behind the
vehicle, if the "Camera delay" setting is
active on the Alfa Connect system.
NOTE The displayed image may look a bit
distorted.