Alfa Romeo Tonale, Owner'S Handbook Manual, Page: 209 / 296

207
FUSES
172) 173) 76)
WARNING
172) Replacement of a fuse. Any service
must be carried out exclusively by the Alfa
Romeo Dealership or by a qualified repairer.
The replacement of a fuse by a third party
may cause a serious car fault.
173) Installation of electrical accessories.
The vehicle's electrical circuit is designed
to operate with standard or optional
equipment, before installing other electrical
equipment or accessories on the vehicle,
contact the Alfa Romeo Dealership or a
qualified repairer.
IMPORTANT
76) FCA declines all responsibility for
expenses arising from the repair of the
vehicle or for anomalies resulting from the
installation of accessories not supplied or
not recommended by Alfa Romeo and not
installed according to specifications, in
particular when the combined consumption
of all the additional equipment connected
exceeds 10 mA.
CHANGING A WHEEL
(where provided)
174) 175) 176) 177) 178) 179) 180) 181) 182)
JACK
Please note that:
the jack weight is 2.8 kg
the jack requires no adjustment
the jack cannot be repaired; in the
event of a fault it must be replaced by
another original one
no tool other than its cranking device
may be fitted on the jack
Maintenance
prevent any dirt from depositing on
the "worm screw"
keep the "worm screw" lubricated
Never modify the jack
Conditions for non-use
temperatures below −40°C
on sandy or muddy ground
on uneven ground
on steep roads
in extreme weather conditions:
thunderstorms, typhoons, hurricanes,
blizzards, storms, etc...
in direct contact with the engine or for
repairs under the car
on boats
WHEEL REPLACEMENT PROCEDURE
Proceed as follows:
stop the car in a position that is not
dangerous for oncoming traffic where
you can change the wheel safely, as far
as possible from the side of the road. The
ground must be as level and compact as
possible
switch on the hazard warning lights
and engage the electric parking brake
take the gear lever to the P (Park)
position
switch off the engine
make sure that any passengers get
out of the car and go to a safe place
where they will not obstruct traffic or
be exposed to the risk of injury. In the
event of a puncture, change the tyre in
accordance with the laws of the country
in which you are travelling
before getting out of the car, put on
the reflective safety jacket (if required
by the regulations in force). In any case,
follow the road safety laws in force in the
country where you are travelling
The space-saver wheel (where provided)
is located under the load platform in
the boot. where provided, the tools
are located in the tool compartment
in the space-saver wheel well. To
access the space-saver wheel and tool
compartment, lift the load platform
using the handle fig. 210.