Alfa Network AWAP05O, User Manual

Page: 60 / 226

System Configuration
6-10
6
Remote IP Address – IP address of the remote end of the PPPoE tunnel. (Must be
entered for static IP allocation mode.)
CLI Commands for PPPoE – From the CLI configuration mode, use the interface
ethernet command to access interface configuration mode. Use the ip pppoe
command to enable PPPoE on the Ethernet interface. Use the other PPPoE
commands shown in the example below to set a user name and password, IP
settings, and other PPPoE parameters as required by the service provider. The
pppoe restart command can then be used to start a new connection using the
modified settings. To display the current PPPoE settings, use the show pppoe
command from the Exec mode.
DUAL OUTDOOR(config)#interface ethernet 7-61
Enter Ethernet configuration commands, one per line.
DUAL OUTDOOR(if-ethernet)#ip pppoe
7-54
DUAL OUTDOOR(if-ethernet)#pppoe username mike 7-58
DUAL OUTDOOR(if-ethernet)#pppoe password 12345 7-59
DUAL OUTDOOR(if-ethernet)#pppoe service-name classA 7-59
DUAL OUTDOOR(if-ethernet)#pppoe ip allocation mode static 7-54
DUAL OUTDOOR(if-ethernet)#pppoe local ip 10.7.1.200 7-57
DUAL OUTDOOR(if-ethernet)#pppoe remote ip 192.168.1.20 7-58
DUAL OUTDOOR(if-ethernet)#pppoe ipcp dns 7-55
DUAL OUTDOOR(if-ethernet)#pppoe lcp echo-interval 30 7-56
DUAL OUTDOOR(if-ethernet)#pppoe lcp echo-failure 5 7-56
DUAL OUTDOOR(if-ethernet)#pppoe restart 7-60
DUAL OUTDOOR(if-ethernet)#end
DUAL OUTDOOR#show pppoe
7-60
PPPoE Information
======================================================
State : Link up
Username : mike
Service Name : classA
IP Allocation Mode : Static
DNS Negotiation : Enabled
Local IP : 10.7.1.200
Echo Interval : 30
Echo Failure : 5
======================================================
DUAL OUTDOOR#