Alfa Network AWAP05O, User Manual

Page: 158 / 226

Command Line Interface
7-44
7
Bridge Commands
The commands described in this section are used to set the MAC address table
aging time and spanning tree parameters for both the Ethernet and wireless
interfaces.
bridge timeout
This command sets the aging time for both the Ethernet port and the wireless
interface.
Syntax
bridge timeout < interface-id > < seconds >
• interface-id - An identifier that specifies the interface. (0 for Ethernet, 2 for
802.11a wireless)
• seconds - The time to age out an address entry. (Range: 60-1800 seconds)
Default
Ethernet: 100
802.11a wireless: 1800
Command Mode
Global Configuration
Command Usage
• If the MAC address of an entry in the address table is not seen on the
associated interface for longer than the aging time, the entry is discarded.
Example
Command Function Mode Page
bridge timeout Sets the aging time for the address table GC
7-44
bridge stp-bridge spanning-tree Enables the spanning tree protocol for the bridge GC 7-45
bridge stp-bridge forward-time Configures the spanning tree bridge forward time GC 7-45
bridge stp-bridge hello-time Configures the spanning tree bridge hello time GC 7-46
bridge stp-bridge max-age Configures the spanning tree bridge maximum age GC 7-46
bridge stp-bridge priority Configures the spanning tree bridge priority GC 7-47
bridge stp-port path-cost Configures the spanning tree path cost of a port GC 7-48
bridge stp-port priority Configures the spanning tree priority of a port GC 7-48
bridge stp-port portfast Sets a port to fast forwarding GC 7-49
bridge stp-port
spanning-disabled
Disables the spanning tree protocol on a port GC 7-50
show bridge Displays the current aging time settings Exec
7-50
Outdoor Bridge(config)#bridge timeout 0 300
Outdoor Bridge(config)#bridge timeout 2 1000
Outdoor Bridge(config)#