Translation of the original operating instructions
Changing the oil
(Figure 3)
Check oil level regularly.
Check oil level every 8 operating hours or daily prior to
starting the engine (see oil recommendations).
Warning!
The fuel tank must be emptied before draining the
oil. Fire and explosion hazard is created through
leaking fuel if instruction not observed.
Drain the used oil while the engine is warm.
Warm oil drains quickly and completely.
1. To drain the fuel tank, let the engine run until it runs
out of petrol.
2. Remove spark plug cap (Component index, Item 6).
3. Place a suitable container under the engine to catch
the oil.
4. Screw out the dip stick (Component index, Item 5).
5. Tilt the engine towards the container so that the oil
can drain fully from the drain opening (G).
6. Place engine back into the horizontal position.
7. Fill with new oil (SAE 10W-30, quantity: 0.55 l).
8. Screw in dip stick.
Dispose responsibly of used oil.
Spark plug maintenance
Warning!
Never check for spark when the spark plug is re-
moved.
The spark plug’s (H) electrode gap should be 0.7 mm - 0.8
mm.
Never start the engine without spark plug.
An incorrect spark plug can cause engine
damage.
Clean engine
Attention - Fire hazard!
Remove combustible material from exhaust and
cylinder area.
Regularly clean dirt from engine using a rag or a brush.
Clean cooling openings.
Do not hose down engine with water.
Clean with brush or rag.
Clean the cooling system. Also clean the internal cooling
fins and surfaces from time to time to prevent overheating.
Maintenance schedule
Follow the hourly or annual intervals, depending on which
occurs first. More frequent maintenance is required under
more severe operating conditions.
After the first 5 hours
Change oil
Every 5 hours or daily before use
Check oil level
Clean silencer area and operating controls
Every 25 hours or every 3 months
Clean air filter; clean more frequently where there is
increased dust or other contamination in the air
Every 50 hours or annually
Change oil
Check silencer and spark arrestor
Annually
Replace air filter
Replace spark plug
Clean air cooling system; clean more frequently where
there is increased dust or other contamination in the air
Summary of Contents for PRO 140 /QSS OHV
