99
OUTPUT <cpd>
Set the output to <ON>, <OFF>, <NORMAL> or <INVERT>
ZLOAD <cpd>
Set the output load, which the generator is to assume for amplitude
and dc offset entries, to <1..10,000>Ohms or <OPEN>.
SQRSYMM <nrf>
Set the square waveform symmetry to <nrf> %
RMPSYMM <nrf>
Set the ramp waveform symmetry to <nrf> %
SYNCOUT <cpd>
Set the sync output to <ON>, <OFF>
SYNCTYPE <cpd>
Set the sync type to <AUTO>, <CARRIER>, <MODULATION>,
<SWEEP>, <BURST> or <TRIGGER>
PHASE <nrf>
Set the waveform phase offset to <nrf> degree.
ALIGN
Sends signal to align zero phase reference of both channels.
Pulse Generator Commands
PULSFREQ <nrf>
Set the pulse waveform frequency to <nrf> Hz
PULSPER <nrf>
Set the pulse waveform period to <nrf> sec
PULSWID <nrf>
Set the pulse waveform width to <nrf> sec
PULSSYMM <nrf>
Set the pulse waveform symmetry to <nrf> %
PULSEDGE <nrf>
Set the pulse waveform edges (positive and negative edge) to <nrf>
sec. Value zero sets to the minimum value allowed.
PULSRANGE <cpd> Set the pulse rise and fall range to <1>, <2> or <3>.
1 sets the range from 5ns to 99.9ns
2 sets the range from 100ns to 1.999us
3 sets the range from 2us to 40us
PULSRISE <nrf>
Set the pulse waveform positive edge to <nrf> sec
PULSFALL <nrf>
Set the pulse waveform negative edge to <nrf> sec
PULSDLY <nrf>
Set the pulse waveform delay to <nrf> sec
Noise Generator Commands
NOISADD <cpd>
Select <ON> to add the noise to the output waveform and <OFF> to
remove the noise from the output waveform.
NOISLVL <nr1>
Set the output noise level to <nr1> %
WAVELVL <nr1>
Set the output waveform level to <nr1> %
PRBS Generator Commands
PRBSBITRATE <nrf>
Set the PRBS waveform bit rate to <nrf> bits per second.
PRBSEDGE <nrf>
Set the PRBS waveform edges to <nrf> sec.
Arbitrary Waveform Commands
ARBDCOFFS <nrf>
Set the arbitrary dc waveform offset to <nrf> Volts
ARBLOAD <cpd>
Set the output waveform type to <DC>, <SINC>,
<EXPRISE>, <LOGRISE> <RAMPUP>, <RAMPDN>,
<TRIANG>, <SQUARE>, <ARB1>, <ARB2>, <ARB3>,
<ARB4>, <”USRNAME1”>, <”USERNAME1”>,
<”USERNAME2”>, <”USERNAME3”> or
<”USERNAME4”>.
