Agilent Technologies 54657A, User Manual

Page: 35 / 89

To make delay measurements automatically
You can measure the delay of signals connected to the oscilloscope’s input 1
and input 2 connectors when the Measurement/Storage Module is connected
to the oscilloscope.
Delay is measured from the user-defined slope and edge count of the signal
connected to input 1, to the defined slope and edge count of the signal
connected to input 2.
1
Adjust controls so that a minimum of 6 full cycles of the signals
connected to inputs 1 and 2 are displayed.
2
Press
Time
.
3
Press the
Next Menu
softkey until the
Define Thresholds
softkey is
displayed on the far left side.
4
Press the Define Delay softkey.
A softkey menu with five softkey choices appears. Four of them are related
to defining the delay measurement.
•
Chan 1
Selects the channel 1 slope (rising or falling) where the delay
measurement will START. Threshold level is always 50%.
•
Edge
Selects the edge count (from 1 to 5) where the delay measurement
will START.
•
Chan 2
Selects the channel 2 slope (rising or falling) where the delay
measurement will STOP. Threshold level is always 50%.
•
Edge
Selects the edge (from 1 to 5) count where the delay measurement
will STOP.
•
Previous Menu Returns you to the previous softkey menu.
5
Use the displayed softkeys to specify the starting (from) and stopping
(to) slope and edge count. Transition point (measurement threshold
level) is fixed at 50%.
6
Press the Previous Menu softkey.
Operating the Measurement/Storage Module
To make delay measurements automatically
2–19