Safety Notes
The telephone system is intended for connection to an ISDN basic rate access (DSS 1). You
may also connect any type of analogue telephone to the system which has been approved
for connection to the Public Switched Telephone Network (PSTN). You may also connect all
DSS 1 ISDN terminals to an internal S0 bus that has been approved for direct connection to
the ISDN network.
Doorphones must conform to the specification of the respective interface. Any other use of
the system is not permitted and therefore illegal
The telephone system has a general connection permit (Germany: AAE).
The telephone system conforms to the prescribed conformity and safety regulations.
About this User Manual
The instruction is valid for the default setting of the system. If the system should be
modified due to software made available through the manufacturer then it may be possible
that sections of the instruction manual become invalid. All listed ISDN features will be
supported by the system. However, some features may not be available through the
Network Operator.
- Installation and Maintenance of the System only by trained personnel.
- Important! To prevent personal injury and damage to equipment please ensure that the
system is properly earthed and that the appropriate cable is connected in the mains plug.
- The System must be installed horizontal so that the connection panel is on the right hand
side.
- Do not connect or disconnect any PSTN lines during a thunderstorm.
- Install lines and extensions in such a way that no one walks or trips over them.
- Disconnect the System from the mains supply before opening the connection panel.
Before connection of lines and extensions please ensure that the system is unplugged
from the mains supply. DANGER!
- Preventive measure! Before carrying out any installation work, please touch briefly the
PC/Printer socket of the telephone system. This will discharge any possible electrostatic
charges, thus protecting the telephone system’s electrostatically sensitive components.
- Do not allow liquids to enter the system as short-curcuits may occur.
- No liability will be accepted for consequential damages such as an unintentional
continued connection of a line.
- The telephone system will not operate in case of power failure and you will not be able to
make any type of call.
Summary of Contents for AS 100 IT
