AGFEO AS 100 IT, Manual

Page: 122 / 204

2 - 18
Analogue and
ISDN-Phones
Notes
Check your Auto Dialling setting after programming the external phone number. Activate the
Auto Dialling mode, lift the receiver, wait -until the external phone number is dialled and
check that the right connection is -established.
The Auto Dialling function has preference over all other external connections. If necessary,
one line (one B-channel) will be force released in order to complete autodial.
If the called party is busy, the telephone -system attempts to redial the external phone
number every 10 seconds.It cancels Auto Dialling after 12 -attempts.
If you hear the error tone when you activate the Auto Dialling feature, no telephone number
has been programmed.
If the Auto Dialling feature is on, you hear the special dial tone when you pick up the -receiver.
Busy on Busy
An ISDN terminal that is connected in parallel to the telephone system on a point-to-
multipoint line and to which the same number as the system has been assigned will always
ring, regardless if BUSY ON BUSY is active or not.
Notes
h P S 4 6 P Z P Z P R Q P ª
Lift receiver Replace
receiver Switch busy on busy
1 = on
0 = off
on / off: Enter the external-
phone number Conclude input,
Acknowledgement
tone
This feature is used in the following situation. If an incoming line is programmed to ring
several phones, then each time a new call arrives the free extensions within the group will
ring. If, however, for some reason your are the only one in the office and are already on a call
then the next incoming call would cause the free extensions to ring. It may not be possible to
answer the new call in time and therefore the caller may get the impression that no one is in
the office. If Busy on Busy is set on the other hand than any extension within the ringing
group who is on a call will cause for a new caller to hear busy tone. Note: This will not place
restrictions on outgoing calls.