AGFEO AS 100 IT, Manual

Page: 171 / 204

3 - 17
Programming your
System
ST 25 DECT 30 ST 30
Downloading new software
The AGFEO ISDN telecommunications systemd can be updated to the latest software ver-
sion without tampering with the telecommunications system hardware. You can download
the new software into the telecommunications system via a PC connected to the telecom-
munications system’s serial RS 232 C interface. If your telecommunications systems has
an internal S0 bus, you can also download software via a PC featuring an ISDN card con-
nected to the internal S0 bus.
Your dealer can also remotely download the new software by ISDN into your
telecommunications system.
Connect ion via RS 232 C Bus
- Connect the telecommunications system’s RS 232 interface (D-SUB-9 socket) to the
PC’s COM port.
For connection, use the PC cable belonging to the telecommunications system or a one-
to-one V.24 extension cable featuring a male and a female connector (mouse or joystick
extension cable). It must not be more than 3 m long.
Save Configuration Data
- Start the "TK-Set" configuration program on your PC
- Read all data out of the telecommunications system (F8).
- Save the data on the hard disk or on a diskette.
System requirements
Update you software
- IBM- or compatible PC with hard disk and CD ROM drive
- Pentium II 233 MHz or higher
- at least 64 MB RAM
- Microsoft Windows 98/2000/ME/XP
- RS 232 C-or USB interface
- Unpacked the Firmware Update Files into the "Updates" subdirectory of the TK-Soft di-
rectory on your hard disk (eg. "C:\TKSoft\updates").
- Start the "TK-Flash" update program
Refer to the online help for details of how to operate "TK-Flash".
The new software is now loaded into the telecommunications system. You cannot make
any telephone calls during the load operation (approximately 5 minutes). You can observe
the load process on the PC’s monitor.
- End "T K-Flash ".
- Clear the telecommunications system’s memory from the system telephone or from an
a/b telephone. (page 3-15)