16
Set screw
Adjusting the Guide Collars
Many of the metal rollers include adjustable guide collars to keep the media to a straight path. You will
need to adjust the guide collars during the initial setup, and any time you change media widths.
Only the collars on the operator side of the DLP-2100 should be adjusted.
The collars to the rear of the
DLP-2100 are in line with the unwinder back plate and should not need to be moved when the media
has been correctly loaded.
1.
Loosen the set screw on any collar that needs to be repositioned
2.
Position the collar so it is just out of contact with the media
a.
Do not position the collars closer together than the width of your media
3.
Tighten set screw to hold collar in place
4.
Repeat with each collar in the DLP-2100
It is recommended that you
follow the paper path from
the input media roll to the
output roll(s) when
adjusting collars to verify
that all are in the correct
positions.
Note that there may be as
many as 17 collars that need
to be adjusted, depending
on the media path and
laminate. Rollers with
collars are shown below
(green).
Laminate Path shown for lined laminate to
include all collars needing adjustment
See page 21 for instructions on loading
unlined or self-wound laminate
