24
10.
Run a few cuts to verify the die plate alignment.
a.
If the lateral alignment needs adjusting, try
the lateral cylinder adjustment first; if
there’s not enough space for adjusting the
cylinder position, remove and re-attach the
die plate.
b.
If the die is cutting too soon or too late, use
the
Die Offset
on the Main screen to adjust
the position.
i.
Range: -10mm to +10mm
ii.
Increase the value to move the cut
to a later position; lower the value to move to an earlier position.
11.
Verify that the die plate is not skewed on the cylinder.
a.
If you see a consistent shift of position of the cuts between the bottom of one plate cut
and the top of the next, the die plate is not straight on the cylinder. Remove and re-
attach the die plate.
12.
Once the die is aligned and the cut is positioned, you are ready to begin cutting.
Removing plates
Use these instructions to remove a cutting plate from your magnetic cylinder. The die tool is designed
for removing cutting plates without damaging the surface of the magnetic plate. Never use other tools
or instruments or you may damage the face of the magnetic cylinder which will cause serious damage to
your DLP-2100.
1.
Touch the
Manual
button on the Main screen.
2.
Watching the cylinder, touch and hold the button labeled
Cylinder and Feed Rollers
until
the top of the die plate is about two-thirds of the way up.
3.
Using the die tool, carefully lift one corner
of the cutting plate until you are able to
grasp the cutting plate.
4.
Continue rotating the cylinder from the
Manual
screen while pulling the die away
from the cylinder until the die is
completely free.
