13
Printer On | Printer Auto | Printer Off
Set the printer operational state by touching one of the three buttons.
Printer On
allows the printer to print at any point, regardless of the press operational status.
Printer Auto
will pause the printer when the press is stopped and continue printing when it is changed
to the running state.
Printer Off
will pause the printer until this setting is changed to On or Auto.
Print Speed
Indicates the print speed as entered in the Settings screen.
Die Offset
Adjusts the top of cut position for fine-tuning position of the cut along the direction of media travel.
Either touch the small button to the right of the number to bring up the numeric keypad or use the two
arrow buttons to change the value.
Home Cycle
Touch this button if the message below the button line says
Machine needs Homing
to sync with the
registration marks.
This is necessary after an Emergency Stop, at a splice point, or if the registration setting has been off but
has been turned back on.
Auto | Semi-auto
Touch this button to toggle between
Automatic
and
Semi-automatic
mode. Semi-automatic mode will
run 1 revolution of the cylinder after the
Start
button is touched and stop.
Start
and
Stop
Starts and stops the cutter operation. Stopping will always occur at the Home position.
Stop
Stops the cutting.
Loop Sensor status
If the Loop Sensor has been set to bypass mode, this button will read
Loop Sensor Off
, and can be
pressed to turn the loop sensor back on. The loop sensor cannot be turned off from this screen; touch
Settings
to open the Settings screen if the sensor needs to be bypassed.
Settings
Opens the Settings screen.
Manual
Opens the Manual operation screen.
