88
22.
Cooling holes in bottom of cowl for standard
mufflers.
Note:
Take care and test painted areas prior to
using any type of paint remover, rubbing
alcohols or cleaners to remove any pen lines
23
Typical cut out for standard style mufflers.
Note:
We have found this to be adequate cooling
for the DA150. Depending on your engine’s
operating temperature, you may need to allow
for more exit air cooling for your engine to run
at its recommended operating temperature.
Always check the operating temperature of
your engine to prevent any damage from
occurring. Aeroworks is not responsible for
damages incurred from improper engine
cooling.
Cowl Preparation for
Canister mufflers
1. Cowl installed with canister muffler installa-
tion.
2.
Gather the cowl and provided air exit hole
template as shown. Use the procedures in the
previous steps for the standard muffler
installation, to mount the template to the
cowl and mark the exit air cut outs.
