92
1. Gather the (4) 8-32 wing mounting bolts, (4) #8
large rubber backed washers and (4) hair pins.
Note:
Always check wing attachment bolts are
securely tightened. We recommend using
hair pins through the aluminum anti-rotation
dowels for a second method of security.
PRE-FLIGHT PREPARATION
2.
Slide the wing tube in the fuse wing tube
sleeve. Slide the wings on the wing tube and
plug in the aileron servo connectors. Slide the
rubber backed washers on the wing mounting
bolts and insert bolts through the fuse side and
into the wing root blind nuts. Tighten snugly
but do not over tighten and crack the fuse or
wing root wood.
3.
Gather the (4) 4-40 stab mounting bolts and
(4) #6 small rubber backed washers.
4.
Slide the stab tubes in the fuse stab tube
sleeves (
short tube front, long tube rear
).
Slide the stabs on the stab tube and plug in the
elevator servo connectors. Slide the rubber
backed washers on the stab mounting bolts and
insert bolts through the stab mounting tabs and
into the fuse blind nuts. Tighten snugly but do
not over tighten and crack the stab mounting
tabs or the fuse sides.
We recommend using hair pins through
the anti-rotation dowels for a second
method of wing attachment.
If you do not remove your stabs for transportation
purposes. We recommend you use (blue) Loctite to
help keep bolts from vibrating loose.
We recommend checking the stab
mounting bolts after each flying
session
