72
6.
Install the fuel tubing as shown securing with
small nylon ties. You will need an after
market fuel “T” and fuel filling dot. We
recommend looping the vent line to the rear of
the fuel tank as shown to prevent fuel spilling
when the model’s tail is lifted or flying a
down line. We have found this will give you
longer flying times with the same size fuel
tank.
7.
Install the fuel filling dot as desired on the side
of the fuse. Do not allow the fuel dot to
interfere with the leading edge of the wing.
Note
: The higher you mount the fuel fill dot the
less fuel will siphon out when fueling.
8. Mark and drill the fuel vent exit hole on the bot-
tom of the fuse. Cut off excess fuel line as
shown.
Note:
We have supplied rubber grommets for you
to route the fuel line through to give a finished
professional
look.
9. Route the line to the engine carburetor out of the
bottom of the engine box and bottom engine box
cover. Use rubber grommets where the fuel line
goes through the plywood to prevent fuel line
chafing.
Note:
It is recommended you always use a fuel
filter in the carburetor line.
