20
5.
Remove the 4-40 ball link from the control
horn.
4. Using a Dremel cut off wheel cut the carbon
tube to correct length.
Note:
Seal ends of carbon tube with thin CA to
help prevent ends from splitting.
6. Remove the 4-40 ball link and lock nut from the
pushrod.
Note:
Make sure lock nut against servo arm ball
link is tight so pushrod length will not change.
7. Slide carbon reinforcing tube over the 4-40
pushrod and reassemble ball link to pushrod end.
Note:
Make sure lock nut against servo arm ball
link is tight so pushrod length will not change.
