32
Aeroworks 30cc Laser 200 Assembly Manual
10. Apply 5 minute epoxy to the side of the servo
mount that will be in contact with the fuse side.
11. With servo arm still 90 degrees to servo and
throttle arm of carburetor in the center or half
throttle position. Mark the cut location for the
throttle push rod.
12. Remove pushrod from throttle arm on carburetor
and cut throttle pushrod to length.
13. Gather the soldering tools as shown below.
Note:
For best results we recommend a high
quality silver solder like “Sta-Brite” Silver
Solder.
14. Lightly sand end of pushrod for best bond.
15. Solder the threaded brass coupler to the end of
the throttle pushrod.
