50
Aeroworks 30cc Laser 200 Assembly Manual
3. Slide wing back against the fuse as shown be-
low.
4. Install “CG Buddy” on the opposite wing using
the same methods described above.
7.
Lift airplane from center handle as shown, plane
should sit level when lifted. Balance the Laser
200 without fuel in the tank with the batteries
installed and
READY TO FLY
. Try to balance
the model by moving the batteries and receiver
before adding any ballast.
5. Attach loop to cable attachment as shown below.
6. Slide wing back against fuse insuring both wings
are pushed firmly against fuse.
Low
Rate Medium
Rate
Aileron
1 1/2” or 18˚ up
2 1/2” or 30˚ up
1 1/2” or 18˚ down 2 1/2” or 30˚ down
Rudder
20˚ left
30˚left
20˚ right
30˚right
Elevator
3/4” or 11˚ up
1 1/4 ” or 20˚ up
3/4” or 11˚ down
1 1/4” or 20˚ down
For 3D flying use the following throws:
High
Rate
Aileron
3 1/2” or 45˚ up
3 1/2” or 45˚ down
Rudder
45˚ left
45˚ right
Full rudder deflection is typically
recommended for all out 3D
Elevator
5” or 45˚ up
5” or 45˚ down
Recommend Expediential:
25% expediential on low rates
45% expediential on medium rates
60% expediential on high rates
Use the given rates as a starting point. Then
adjust rates to suit your own flying style.
CONTROL THROW
DEFLECTION TABLE
