Aeroworks 30cc Laser 200 Assembly Manual
13
2. Apply 30 minute epoxy into vertical stab post
slot as shown below.
3. Slide vertical stab into fuse as shown. Use paper
towels and denatured alcohol to wipe away any
excess epoxy.
4. Allow epoxy to fully cure before continuing
with assembly. While the epoxy cures ensure
that the vertical stab is sitting flat to the top of
the fuse. Masking tape may be used to hold ver-
tical stab in place until epoxy cures.
5. Cut 8mm strip of covering from the supplied
spare covering sheets. Use a trim iron to seal
covering over the vertical stab and fuse joint as
shown. This will completely hide the vertical
stab/fuse seam.
6. Repeat for remaining colors and both sides of
vertical stab.
7. Repeat steps 5 and 6 for horizontal stab as
shown below.
