2.1. Input Power Connections
The XL5e has two AC input power connectors. One connector is for control power and the other
connector is for motor power. For a full list of electrical specifications, refer to
2.1.1. Control Supply Connector
The Control Supply input supplies power to the communications and logic circuitry of the XL5e. The
L
input is connected to an internal fuse. Refer to
for the internal fuse value and part number.
The
N
input is not connected to an internal fuse. An external fuse will be required if
N
is not connected
to Neutral.
The Control Supply contains an internal filter but you could be required to add an external filter for CE
compliance. Install the external filter module as close as possible to the XL5e. Use a Schaffner FN2080
filter, an Aerotech UFM-ST noise filter module, or equivalent device.
IMPORTANT
: Refer to local electrical safety requirements to correctly size external system
wires.
Figure 2-1:
Control Supply Connections
Table 2-1:
Control Supply Wiring Specifications
Pin
Description
Recommended Wire Size
L
Line (L): 100-240 VAC Control Power Input
0.8 mm
2
(#18 AWG)
N
Neutral (N) or 100-240 VAC Control Power Input with external
fuse
0.8 mm
2
(#18 AWG)
Protective Ground
0.8 mm
2
(#18 AWG)
Table 2-2:
Mating Connector Part Numbers for the Control Supply Connector
Type
Aerotech
P/N
Third Party
P/N
Screw
Torque: N·m
Wire Size:
mm
2
[AWG]
3-Pin Terminal Block
ECK00213
Phoenix 1754465
0.5 - 0.6
3.3 - 0.516 [12-30]
2.1. Input Power Connections
XL5e Hardware Manual
26
www.aerotech.com
Summary of Contents for Automation1 XL5e
Page 1: ...Revision 1 01 Automation1 XL5e High Performance Linear Digital Drive HARDWARE MANUAL...
Page 22: ...Figure 1 4 Dimensions EB1 1 2 2 Dimensions XL5e Hardware Manual 22 www aerotech com...
Page 63: ...Figure 2 32 PSO Interface XL5e Hardware Manual 2 5 Auxiliary I O Connector www aerotech com 63...
