Appendix B: Voltage Selection Operation
DANGER
: Voltage selector settings must not be changed with Mains power applied to the
unit.
DANGER
: Wait at least ten (10) minutes after removing the power supply before
performing maintenance or an inspection. Otherwise, there is the danger of electric shock.
WARNING
: The voltage selector must be configured to match the AC line voltage on the
Motor Supply Connector and is factory-configured based on the options that you ordered.
You could damage the unit if the voltage selector is set for the incorrect AC input voltage.
The voltage selector can only be used with transformer-derived bus voltages. This voltage
selector function should not be changed when using off-line supplies. Damage to the unit
may result if this function is used improperly.
If the user changes the voltage selector settings, it is also the user's responsibility to change
the XL5e AC power label located next to the Motor Supply connector. Refer to the
for power ratings.
Procedure for setting AC voltage selector switches:
1. Turn-off and disconnect all power from unit.
2. Set the S1 and S2 switches for your voltage on the Motor Supply Connector.
NOTE: Refer to
to see how switch position relates to voltage selection.
3. Apply a visible indicator on the drive that lets the user know that the voltage input configuration
has changed and that the factory order part number no longer represents the current con-
figuration.
XL5e Hardware Manual
Appendix B: Voltage Selection Operation
www.aerotech.com
101
Summary of Contents for Automation1 XL5e
Page 1: ...Revision 1 01 Automation1 XL5e High Performance Linear Digital Drive HARDWARE MANUAL...
Page 22: ...Figure 1 4 Dimensions EB1 1 2 2 Dimensions XL5e Hardware Manual 22 www aerotech com...
Page 63: ...Figure 2 32 PSO Interface XL5e Hardware Manual 2 5 Auxiliary I O Connector www aerotech com 63...
