AEQ
CAPITOL
Ultra-compact digital audio mixer
23
In order to make installation process easier, AEQ offers specific pre-fabricated cable kits for
AEQ CAPITOL data input/output within the optional modules range: CP CAB GPIO, consisting
on a DB15 male connector soldered to a 6 meters long cable with no connectors at the other
end. For more information please check chapter 2.2.6 of this manual.
Relay GPO Outputs (SUB-D female, 15 pins):
Pin Signal Pin Signal
1 GPO_RL1_NO 9 GPO_RL1
2 GPO_RL1_NC 10 Not
connected
3 GPO_RL2_NO 11 GPO_RL2
4 GPO_RL2_NC 12 Not
connected
5 GPO_RL3_NO 13 GPO_RL3
6 GPO_RL3_NC 14 Not
connected
7 GPO_RL4_NO 15 GPO_RL4
8 GPO_RL4_NC
AEQ can upon request provide fully finished cables and in special lengths. For more information
please refer to AEQ sales department or authorised distributors.
2.2.2.2. Ethernet Port.
Located in the lower left part of AEQ CAPITOL back chassis you can find an Ethernet RJ45
10/100BaseT socket labelled “
LAN
” for connection to external devices using IP communications
protocol.
This socket permits connection of AEQ CAPITOL console to one or more external computers
where Setup and, in future versions, Remote Control and/or Capitol Screen software are
running.
For more information please check chapter “
4. CONFIGURATION SOFTWARE
”
in this manual.
RJ45 connector pinout is as follows:
NO: normally open
NC: normally close
COM: common
Pin 4:
Blue
Pin 3:
White and Green
Pin 2:
Orange
Pin 1:
White and Orange
Pin 5:
White and Blue
Pin 6:
Green
Pin 7:
White and Brown
Pin 8:
Brown
