AEQ
CAPITOL
Ultra-compact digital audio mixer
29
-
Programming digital outputs as S/PDIF.
In order to provide outputs to S/PDIF equipments, the programming procedure
described below adapts the levels and unbalances the signals by joining OUT1- ,
OUT2-, OUT3-, and OUT4- to their corresponding GND, so the signal is taken from
each OUT+ to OUT– (or GND).
Start by following the steps detailed at chapter 2.2.3.1 (it’s
VERY IMPORTANT
to turn
first the equipment off and disconnect the power supply cable). Then, at the “DIGITAL
INPUTS AND OUTPUTS PROGRAMMING ZONE”, you can change the outputs one by
one from AES/EBU to S/PDIF by moving the 4 jumpers associated to each output from
position 1-2 (up) to position 2-3 (down), as shown in the following image:
2.2.3.4. Analog inputs.
AEQ CAPITOL includes 12 mono line-level inputs, electronically balanced, available through 3
female DB15 connectors identified as “
ANALOG IN 1-4
”, “
ANALOG IN 5-8
” and “
ANALOG IN
9-12
”.
Analog Inputs (SUB-D female, 15 pins):
Digital output 4
Digital output 3
Digital output 2 Digital output 1
Jumpers J49, J56,
Jumpers J31, J38,
Jumpers J45, J52, Jumpers J28, J34,
J57 and J58
J39 and J40
J53 and J54
J35 and J36
Position 1-2: AES/EBU
Position 2-3: S/PDIF
