AEQ
CAPITOL
Ultra-compact digital audio mixer
95
The available options in the snapshots advanced configuration menu, described from left to
right and top to bottom, are:
•
“
Label
”
:
alphanumeric label for the snapshot memory.
•
“
Faders
”
:
8 drop-down menus allow you to assign an input audio channel to each one
of the 8 physical faders of the control surface. The faders are numbered, from left to
right, 1 through 8.
•
“
Talkback MIC
”
:
allows you to configure the operation of the talkback microphone
(microphone 4) at the rear panel of the AEQ CAPITOL. When “
Self-Control
” checkbox
is
not
activated, that input is configured only as an orders microphone toward studio or
return for any open communication lines (this is a typical configuration for AEQ
CAPITOL when installed in a Studio/Control configuration). When “
Self-Control
”
checkbox is activated, that input 4 is configured as autocontrol microphone (it
simultaneously works as orders microphone), so the host of the radio program is also
the operator of the mixing console (this is a typical configuration when the Studio and
Control areas of the radio station are in the same room). Only when “Self-Control”
checkbox is activated you can assign the talkback mic to a fader (when it’s not
activated, the mic will not appear in the channels list).
•
“
Studio
”
:
section where you can configure the initial activation of one or several keys to
send signal to monitor and headphones placed
under the display of the
studio
monitoring section. The available options are “Program”, “Audition”, “Cue” and “Sel”
(when section is configured in “
Exclusive
” mode, you can activate only one key: see
section 4.2.4.1 of this manual). “
Sel Input
” and “
Sel Out
” drop-down menus allows you
to select a single input, output or internal summing bus to associate it initially with the
“SEL” monitoring key (that selection can be modify later by means of “HP/SOURCE”
encoder).
