Hydro Cat 5015B
Service Manual
VACUUM SYSTEM
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
SQUEEGEE LIFT ACTUATOR REPLACEMENT
1
Manually lift the squeegee and put blocks under it to hold the blades about 2 inches (5.14 cm) off of the
floor. This will support the weight of the squeegee when the actuator is removed.
2
This step is only for machines with the Hydro-Max II option. For standard machines, skip this step and go
to step 3.
•
Remove the 1-1/2 inch (3.8 cm) drain hoses from the left and right sides of the recovery tank. Disconnect
the squeegee and vacuum motor hoses from the recovery tank.
•
Disconnect the wiring connector from the right side of the recovery tank.
3
Raise the recovery tank cover and lift the recovery tank off of the machine.
4
Reach under the battery and disconnect the wiring connector for the squeegee lift actuator.
5
See Figure 7. Remove the (2) “L” bolts and bracket “M” from the squeegee lift linkage.
FIGURE 7 HERE
FIGURE 7
P
Front
L
M
49
