
Hydro Cat 5015B
Service Manual
WHEEL DRIVE SYSTEM
To replace the forward or reverse switch...
1
See Figure 5. Open the front access panel and remove the (2) “J” screws.
2
Pull switch bracket “K” out of the compartment as far as the attached linkage will allow and remove the
switch needing replacement.
3
Install the new switch (or switches) but do not tighten the mounting screws.
4
Reinstall switch bracket “K” but do not tighten the (2) “J” screws. Adjust the switches.
To adjust the forward & reverse switches...
1
See Figure 5. Loosen the (2) “J” screws and the mounting screws in forward and reverse switches.
2
Put a block of wood under the front of the drive pedal. This will hold the pedal in the REVERSE position.
3
Slowly move switch bracket “K” toward collar “H” until the squeegee lift switch clicks. Then continue to
move the bracket an additional 1/16 inch (1.5 mm) toward the collar and tighten the “J” screws.
4
Slide the REVERSE switch towards the switch collar “H” until it clicks. Then move the switch an addi-
tional 1/16 inch (1.5 mm) toward the collar and tighten the switch mounting screws.
5
Remove the block of wood from the front of the drive pedal and put it under the back of the pedal. This
will hold the pedal in the FORWARD position.
6
Slide the FORWARD switch towards the switch collar “H” until it clicks. Then move the switch an addi-
tional 1/16 inch (1.5 mm) toward the collar and tighten the switch mounting screws.
________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________________
FORWARD & REVERSE SWITCH (continued...)
60