ADLINK Technology NuIPC cPCI-6760D Series, Manual

Page: 94 / 128

Getting Started 81
front board, it is recommend that the ATAPI CD-ROM is
connected to the Primary IDE port on the cBP-6108 series
backplane to avoid the possibility of master/slave confliction.
Using cPCI-6760D on other backplanes
For backplanes that are not compatible with the pin assignments
for J3/P3 and J5/P5 rear I/O of IDE interfaces on cPCI-6760D,
connect the 40-pin flat cable into the IDE interface on the cPCI-
R6760 series rear board. Then connect the flat cable into an
ATAPI CD-ROM. If the 2.5” ATA HDD or CF card has already
been installed on the front board, it is recommended that the
ATAPI CD-ROM is connected to the Primary IDE port on the rear
board to avoid the possibility of master/slave conflict. Note that
those backplanes should support P3 to P5 (the CompactPCI
sockets) with direct through I/O on system slot.
Note: The 2.5” ATA HDD or CF card on front board utilizes
the Secondary EIDE interface (IDE2). As the cPCI-
6760D front board supports rear I/O, the IDE2
interface is also wired to rear I/O from CompactPCI
connector J5. Please note that it only supports up to
two IDE devices on each EIDE interface, and the
master/slave setting should not conflict with each
other. As most default settings of the 2.5” ATA HDD or
CF card are set to master, make sure the master/slave
setting does not conflict with the front board’s HDD or
CF card when connecting the ATAPI CD-ROM to the
IDE2 interface on rear I/O (including the rear I/O port
on cBP-6108 backplane and cPCI-R6760 series rear
board).
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com