ADLINK Technology NuIPC cPCI-6760D Series, Manual

Page: 123 / 128

110 Watchdog and Utilities
Insertion Process
This section describes the operational principle during the
insertion process when self hot-swap feature is enabled.
1. The cPCI-6760D enters the card guide.
2. The board is discharged to chassis ground through
bleed resistors and card guide.
3. The board contacts long pins on backplane, and begins
to contact ground, +5V, +3.3V, and VIO pins.
4. Enough pins are connected that a stable Early Power
can be achieved. And the BLUE LED is in the ON state.
5. The board contacts the medium length pins on the
backplane. Medium length power pins contact and short
out the current limiting resistors.
6. The board contacts the short BD_SEL# pin, the handle
is fully closed.
7. If hot insertion was successful, the board powers on and
the blue LED flashes. If not, the blue LED would remain
on. Remove the board and try again.
8. The system BIOS would start up the board and
configuration automatically.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com