80
Getting Started
are all matched
X
Check that the flat cable, HDD and HDD supporting stand-
off are all firmly fixed and connected.
Removing HDD/FFD from cPCI-6760D
X
Remove the four screws from the bottom side that are
mounted on the copper stand-off
X
Remove the 44-pin flat cable from the CN2 of cPCI-6760D
and remove the cable from the HDD
X
Remove the copper stand-off from the HDD
3.5 Device Connection for OS Installation
This section describes the installation process of the OS into the
6U CompactPCI platform for the cPCI-6760D CPU module. The
easiest way to install the OS is by connecting an ATAPI CD-ROM.
Using cPCI-6760D on ADLINK’s cBP-6108, 6105, 6515, and
6402 series backplane
As the cBP-6108 series backplane has direct connections for J3/
P3 and J5/P5 rear I/O of IDE interfaces, and pin assignments are
compatible with the cPCI-6760D series product, users can
connect the 40-pin flat cable into IDE interface on the rear side of
the backplane, then connect the flat cable into an ATAPI CD-
ROM. If the user has installed a 2.5” ATA HDD or CF card on the
Note:
The 2.5" ATA HDD on front board uses Secondary
EIDE interface (IDE2) which is also wired to rear board
via CompactPCI connector J5. Users need to pay
attention to the master/slave setting to avoid conflict
between devices. If the user applies one 2.5" ATA
HDD on front board and setting on master, the IDE2
interface on rear I/O could only apply one IDE device
which is set on slave.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Summary of Contents for NuIPC cPCI-6760D Series
Page 5: ...Artisan Technology Group Quality Instrumentation Guaranteed 888 88 SOURCE www artisantg com...
Page 87: ...74 Artisan Technology Group Quality Instrumentation Guaranteed 888 88 SOURCE www artisantg com...
Page 99: ...86 Artisan Technology Group Quality Instrumentation Guaranteed 888 88 SOURCE www artisantg com...
