ADLINK Technology NuIPC cPCI-6760D Series, Manual

Page: 92 / 128

Getting Started 79
3.4 HDD Installation
In cPCI-6760D, users can install one 2.5” ATA HDD or flash drive
(e.g. FLASH2000 flash disk, FFD) which is 2.5” ATA HDD form
factor. The factory default bare model is equipped with DB-
6760CF, the removable CF card adaptor and not equipped with
any HDD or FFD. If the user wishes to install 2.5” ATA HDD for
larger storage capacity or to install FFD for higher vibration
tolerance, users can purchase the off-the-shelf 2.5” ATA HDD or
FFD from the market. However, ADLINK recommends products
that are approved by ADLINK to ensure the best system stability.
Due to space limitation and ventilation concerns, only low profile
(or called slim type) 2.5” ATA HDD or FFD’s whose thickness is
not more than 9.5mm can be used. Because the CF card adaptor
(DB-6760CF) uses the same IDE interface, and the same housing
that 2.5” ATA HDD might use, hence the user should remove the
CF card adaptor (if any) first then install the 2.5” ATA HDD or FFD.
Please refer to “CF installation” for instructions on removing the
CF card adaptor.
HDD/FFD Installation for cPCI-6760D
X
Find the HDD accessory pack inside the original package.
(If the user purchases the OEM model, non-standard,
customized, or special configuration model, it may not come
with the HDD accessory pack inside the package. Please
contact your ADLINK dealer or sales representative to
purchase this accessory pack (P/N: 58-00023-000).
X
If the DB-6760CF exists, remove this by referring to section
3-3 - “CF Installation”
X
Check the master/slave setting of your 2.5” ATA HDD
X
Screw four copper hexagonal stand-offs on the bottom side
of 2.5” ATA HDD
X
Mount the HDD by using four M3 screws from cPCI-
6760D’s bottom side
X
Connect the HDD and cPCI-6760D (CN2) by flat cable
which is included in the HDD accessory pack
X
Check that pin1 of the IDE connector, flat cable, and HDD
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com