42
Setting
Ceiling
Allows you to project images from a ceiling
mounted projector.
Off.......The projector is in normal vertical position.
Auto........ The projector automatically identifies its vertical or inverse state.
On.......... The projector is reversed.
Rear
When the function is set to On, the picture is left/right reversed.
Allows you to project the image to a rear projection screen.
Terminal
The COMPUTER IN 2/MONITOR OUT terminals on the back of the projector can be used for computer
input or monitor output. Press
▲
/
▼
to select PC 2 or Monitor output.
PC 2 ......... Input from PC 2.
Monitor out ... Output to a monitor.
Power management
Allows reducing power consumption and maintaining the lamp life, the Power control function turns off the projection lamp
when the projector is out of service within a certain period.
Options are:
Ready............When the lamp has been fully cooled down, the POWER indicator changes to flash in green. In this condition,
the projection lamp is turned on if the input signal is reconnected or any button on the control panel or remote
control is pressed.
Shut down............When the lamp has been fully cooled down, the power is turned off.
.f
f
o
s
i
n
o
it
c
n
u
f
l
o
rt
n
o
c
r
e
w
o
P
..
..
..
..
..
..
.
f
f
O
Timer..........If the input signal is interrupted and no key is pressed over 30 seconds, “No signal” appears on the timer.
Then, the system starts to count down till the lamp is turned off. Press
▲
/
▼
to set the timer (1 ~ 30 min.).
√
Note:
Factory default is: Ready: 5 min.
Power control
01 20
Time left before the lamp is off.
On start
Allows the projector to be turned off automatically just by connecting the AC power cord to an outlet when this function is
set to On.
No si
g
nal
