ABB SACE Tmax XT5, Operation And Maintenance Manual

Page: 187 / 205

ABB | SACE Tmax XT
Internal accessories | 5 - Ekip Com IEC 61850 185 | © 2019 ABB | 1SDH002039A1002 - ECN000093027 - Rev. A
Connections
To connect the module to its communication network and for references about the terminals, please consult
circuit diagrams
1SDM000005A1001 .
The module is supplied with a 1-meter length cable and cabled RJ45 connector for interfacing with its
network.
To connect the module to Ekip Touch and to actuator MOE-E if present, please consult document
1SDH002011A1503 .
Power supply
Ekip Com IEC 61850 is supplied directly by the Ekip Touch to which it is connected.
NOTE: communication between Ekip Touch and the module is interrupted in the absence of
auxiliary power supply
Configurations via menu
Local bus activation, which is essential for starting the communication between module and Ekip Touch, is
available in the
Settings menu (page 33).
The following communication parameters can be configured if the module has been correctly detected by
Ekip Touch in the
Settings - Modules menu:
Parameter Description Default
Static IP address ON
Defines whether the module has a dynamic (Off) IP address or
static (On) IP address
Se = On all the associated parameters are enabled
Off
Static address IP address
Enables the static IP to be selected 0.0.0.0
Static Network Mask Enables the subnet mask to be selected 0.0.0.0
Static Gateway address
When there are several subnets, enables the IP address of the
node to which the module is connected to be selected
0.0.0.0
Enable SNTP client
Allows the SNTP protocol for distribution of the clock and
synchronization signal to be enabled.
Off
SNTP Server Addr. Allows the network server that supplies the SNTP to be set. 0.0.0.0
Information in menu
The following information will be available in the About - Modules menu if Ekip Touch has detected the module
correctly:
Information Description
SN and version Identifier and SW version of the module
IP address
Address of the module, assigned to the module by a DHCP server at the time
of connection to the network in the case of configuration with a dynamic IP, or
can be set via the menu in the event of a static IP.
NOTE : without a DHCP server, the module automatically adopts a
random IP address within the 169.254.xxx.xxx range
Network Mask
Subnet mask; identifies the method for recognizing the subnet to which the
modules belong and enables modules to be searched for within a defined set
of recipients.
Gateway address
IP address of the node to which the module is connected, in the presence of
several subnets
MAC address
Address assigned by ABB, with OUI (Organizationally Unique Identifier) equal to
ac:d3:64, which uniquely identifies the manufacturer of an Ethernet device
Cfg file Name of the configuration file uploaded to the modules
Cfg file error Code of the error concerning the configuration file (0 = no error)