ABB i-bus VC/S 4 1 Series, Product Manual, Page: 50 / 199

ABB i-bus® KNX PARAMETERS
This parameter window includes the following parameters:
→ ⁠ Input, Page ⁠⁠75
→ ⁠ Window open if [input x], Page ⁠⁠81
→ ⁠ Send status values [window contact], Page ⁠⁠120
→ ⁠ Send cyclically every, Page ⁠⁠146
→ ⁠ Dew point reached if [input x], Page ⁠⁠126
→ ⁠ Send status values [dew point alarm], Page ⁠⁠121
→ ⁠ Fill level reached if [input x], Page ⁠⁠82
→ ⁠ Send status values [fill level alarm], Page ⁠⁠120
→ ⁠ Temperature sensor type, Page ⁠⁠129
→ ⁠ NTC type, Page ⁠⁠103
→ ⁠ KTY type, Page ⁠⁠94
→ ⁠ Resistance in ohms at x °C, Page ⁠⁠140
→ ⁠ Temperature offset, Page ⁠⁠129
→ ⁠ Cable error compensation, Page ⁠⁠95
→ ⁠ Cable length, single distance, Page ⁠⁠95
→ ⁠ Cross-section of conductor, value* 0.01 mm², Page ⁠⁠110
→ ⁠ Cable resistance (total of fwd and rtn conductor), Page ⁠⁠95
→ ⁠ Filter, Page ⁠⁠82
→ ⁠ Send temperature value, Page ⁠⁠130
→ ⁠ Value is sent from a change of, Page ⁠⁠139
→ ⁠ Distinction between long and short operation, Page ⁠⁠135
→ ⁠ Input on operation, Page ⁠⁠77
→ ⁠ Long operation after, Page ⁠⁠94
→ ⁠ Activate minimum signal duration, Page ⁠⁠101
→ ⁠ When opening the contact, Page ⁠⁠71
→ ⁠ When closing the contact, Page ⁠⁠71
→ ⁠ Enable group object "Block input", Page ⁠⁠93
→ ⁠ Reaction on event x, Page ⁠⁠110
→ ⁠ Send status values [binary input], Page ⁠⁠119
→ ⁠ On group object value, Page ⁠⁠70
→ ⁠ Scan input after download, ETS reset or bus voltage recovery, Page ⁠⁠77
Note
In the following, the possible settings for inputs a … l are explained using input a as an example.
The setting options are identical for all inputs.
Prerequisites for visibility
• The parameter window is in the parameter window Channel X .
Product manual | EN-US | VC/S 4.x.1 | 2CDC508220D0211 Rev. B 50
Note about navigation in the PDF: Key combination 'Alt + left arrow'
jumps to the previous view/page