ABB i-bus VC/S 4 1 Series, Product Manual, Page: 70 / 199

ABB i-bus® KNX PARAMETERS
7.4.23 Limit temperature [cooling]
This parameter is used to define the limit temperature for the Cooling operating mode. When the tem-
perature reaches the set value, the controller sets the control value to 0.
Setting for receipt of the temperature value → parameter Input for temperature limit sensor .
Option
1 … 10 … 30 °C
Prerequisites for visibility
• Parameter window
Channel X
\ Parameter window
Application parameters
– Parameter
Channel function
\ Option
Controller channel
– Parameter
Basic-stage cooling [controller]
\ all options except
Deactivated
• Parameter window
Channel X
\ Parameter window
Temperature controller
\ Parameter window
Basic-
stage cooling
– Parameter Extended settings \ Option Yes
– Parameter Activate temperature limitation \ Option Yes
• The parameter is in the parameter window Channel X \ parameter window Temperature controller \
parameter window Basic-stage cooling .
or
• Parameter window Channel X \ Parameter window Application parameters
– Parameter Channel function \ Option Controller channel
– Parameter
Basic-stage cooling [controller]
\ all options except
Deactivated
– Parameter
Additional-stage cooling
\ all options except
Deactivated
• Parameter window
Channel X
\ Parameter window
Temperature controller
\ Parameter window
Addi-
tional-stage cooling
– Parameter Extended settings \ Option Yes
– Parameter Activate temperature limitation \ Option Yes
• The parameter is in the parameter window Channel X \ parameter window Temperature controller \
parameter window Additional-stage cooling .
7.4.24 On group object value
This parameter is used to define when the value of the group object is sent cyclically.
Option
0 If the value of the group object is 0, this value is sent cyclically after an adjustable time has elapsed.
1 If the value of the group object is 1, this value is sent cyclically after an adjustable time has elapsed.
0 or 1
The value of the group object is sent cyclically after an adjustable time has elapsed.
Prerequisites for visibility
• Parameter window Channel X \ Parameter window Input x
– Parameter Input \ Option Binary input
– Parameter Send status values [binary input] \ Option After change or cyclically
• The parameter is in the parameter window Channel X \ parameter window Input x .
Product manual | EN-US | VC/S 4.x.1 | 2CDC508220D0211 Rev. B 70
Note about navigation in the PDF: Key combination 'Alt + left arrow'
jumps to the previous view/page