ABB i-bus VC/S 4 1 Series, Product Manual, Page: 130 / 199

ABB i-bus® KNX PARAMETERS
Option
PT1000 [-30…+110°C] The temperature sensor type PT1000 is used.
PT100 [-30…+110°C] The temperature sensor type PT100 is used.
NTC
The temperature sensor type NTC is used.
The following dependent parameters are shown:
•
NTC type
KTY [-15…+110] The temperature sensor type KTY is used.
The following dependent parameters are shown:
•
KTY type
NI1000 - 01 [-30…+110°C] The temperature sensor type NI1000 - 01 is used.
NI1000 - 02 [-30…+110°C]
The temperature sensor type NI1000 - 02 is used.
Prerequisites for visibility
• Parameter window Channel X \ Parameter window Input x \ Parameter Input \ Option Temperature
sensor
• The parameter is in the parameter window Channel X \ parameter window Input x .
7.4.133 Send temperature value
This parameter is used to define when the value of the following group object is sent on the bus
(ABB i-bus® KNX):
•
Temperature
Note
Sending on request can be triggered by the reception of a telegram with the value 0 or 1 on group ob-
ject
Request status values .
Option
After change The value is sent if there is a change.
The following dependent parameters are shown:
•
Value is sent from a change of
Cyclically
The value is sent cyclically. The cycle time can be set.
The following dependent parameters are shown:
•
Send cyclically every
After change or cyclically The value is sent after a change or cyclically. The cycle time can be set.
The following dependent parameters are shown:
•
Value is sent from a change of
•
Send cyclically every
On request The value is sent on request.
After change or on request The value is sent after a change or on request.
The following dependent parameters are shown:
•
Value is sent from a change of
On request or cyclically
The value is sent on request or cyclically. The cycle time can be set.
The following dependent parameters are shown:
•
Send cyclically every
After change, on request or
cyclically The value is sent after a change, on request or cyclically. The cycle time can be set.
The following dependent parameters are shown:
•
Value is sent from a change of
• Send cyclically every
Prerequisites for visibility
• Parameter window
Channel X
\ Parameter window
Input x
\ Parameter
Input
\ Option
Temperature
sensor
• The parameter is in the parameter window Channel X \ parameter window Input x .
Product manual | EN-US | VC/S 4.x.1 | 2CDC508220D0211 Rev. B 130
Note about navigation in the PDF: Key combination 'Alt + left arrow'
jumps to the previous view/page