ABB i-bus VC/S 4 1 Series, Product Manual, Page: 110 / 199

ABB i-bus® KNX PARAMETERS
7.4.91 Cross-section of conductor, value* 0.01 mm²
This parameter is used to define the cross-section of the conductor to which the temperature sensor is
connected.
Note
The option 150 corresponds to a conductor cross-section of 1.5 mm
2
.
Option
1 … 100 … 150
Prerequisites for visibility
• Parameter window
Channel X
\ Parameter window
Input x
– Parameter
Input
\ Option
Temperature sensor
– Parameter Cable error compensation \ Option Via cable length
• The parameter is in the parameter window Channel X \ parameter window Input x .
7.4.92 Reaction on event x
This parameter is used to define which value is sent on the group object Contact position binary input
for event 0 / event 1.
Note
The action that triggers event 0 or event 1 depends on the option in the parameter Distinction be-
tween long and short operation :
• No
– Event 0 = Opening the contact
– Event 1 = Closing the contact
• Yes
– Event 0 = Short operation
– Event 1 = Long operation
Note
The option End cyclic transmission becomes effective only if, in the parameter Send status values [bi-
nary input] , the option After change or cyclically is selected.
Option
No edge evaluation The edge (1 → 0 or 0 → 1 change) is not evaluated. A value is not sent.
On
The value 1 is sent.
Off The value 0 is sent.
Toggle If the value 0 was sent last, the value 1 is sent. If the value 1 was sent last, the value 0 is sent.
End cyclic transmission
Cyclical transmission of the status value is ended.
Prerequisites for visibility
• Parameter window Channel X \ Parameter window Input x \ Parameter Input \ Option Binary input
• The parameter is in the parameter window Channel X \ parameter window Input x .
Product manual | EN-US | VC/S 4.x.1 | 2CDC508220D0211 Rev. B 110
Note about navigation in the PDF: Key combination 'Alt + left arrow'
jumps to the previous view/page