NONE – Start-up
Contents of this chapter
This chapter contains:
•
information on configuring the drive for operation with the adapter module
•
drive-specific instructions on starting up the drive with the adapter module
•
information on configuring the client for communication with the adapter module.
Warnings
WARNING!
Obey the safety instructions given in this manual and the drive documentation.
Drive configuration
The information in this section applies to all drive types compatible with the adapter
module, unless otherwise stated.
■
Connection configuration using NONE protocol
After the adapter module is mechanically and electrically installed according to the
instructions in chapters
and
, you must
prepare the drive for communication with the module.
The detailed procedure of activating the module using the NONE protocol with the
drive depends on the drive type. Normally, you must adjust a parameter to activate
the communication. See the drive-specific start-up sections
.
10
NONE – Start-up 59
Summary of Contents for FMBT-21
