Revision:
Language: Page:
A EN
6/7
1KHW001496-EN
Click
No
to select other files. This opens a
file open
dialog box for each kind of download file.
Click
Cancel
to stop firmware download.
7.
Wait
until the
Close
button changes to the active state.
8. Click
Close
to leave the
firmware download
dialog box.
9.
Download the modified configuration. Please refer to paragraph 3.1 step 12.
3.4
Extend the equipment and the HMI600 informs you about firmware
incompatibilities
1. On
the
File
menu click
New
. This opens the
Connect
dialog box.
2. Click
Logon, Equipment ID: 0
3. Click
Read & Write access
.
4. Click
Upload configuration
.
5. Click
OK
. This opens a HMI600 child window.
6. On
the
Configuration
menu click
Services
and choose new services.
7. On
the
File
menu click
Save
. This opens the
Save as
dialog box. Click
Save
.
8.
Close the HMI600 window (
File
,
Close
).
9.
Switch off the equipment.
10. Plug in the new modules.
11. Switch on the equipment.
12. On the
File
menu click
Open
. This opens the
Open
dialog box. Select the previously saved
configuration file and click Open.
13. From the
Equipment
menu click
Connect
. This opens the
Connect
dialog box.
14. Click
Read & Write access
.
15. Click
OK
.
16. From the
Equipment
menu click
Download configuration
. This process automatically
checks the firmware compatibility of the new modules. If an incompatibility is detected proceed
with chapter 3.3. If not, the firmware is fully compatible to the other modules in the equipment.
3.5
Exchange a module and the HMI600 informs you about firmware
incompatibilities
If you have to exchange a module in case of any damage, switch off the equipment, replace the
new module and switch it on again. You can use the last configuration stored in a file to update the
equipment configuration.
The following steps describes the connect and configuration download process with the HMI600.
1. On
the
File
menu click
Open
. This opens the
Open
dialog box. Select the configuration file
and click Open.
2. From
the
Equipment
menu click
Connect
. This opens the
Connect
dialog box.
3. Click
Read & Write access
.
4. Click
OK
.
5. From
the
Equipment
menu click
Download configuration
. This process automatically
checks the firmware compatibility of the replaced module. If an incompatibility is detected
proceed with chapter 3.3. If not, the firmware is fully compatible to the other modules in the
equipment.
Summary of Contents for ETL600
