ENGLISH
6
3
SAFETY INSTRUCTIONS
WARNING!
Risk of injury from
unintentional gate movement!
In the event of improper
installation or operation of the
opener, unintentional gate
movements may be triggered
which may cause people or
objects to become trapped.
In the event of improperly attached control units (e.g. buttons),
unintentional gate movements may be triggered which may
cause people or objects to become trapped.
►
Follow all instructions contained in this manual.
►
Attach control units at a height of minimum 1.5 m (outside of
the reach of children).
►
Install fi xed control units (e.g. buttons) within sight of the
gate but away from moving parts.
In the event of the failure of safety devices, persons or objects
may become trapped.
►
In accordance with ASR 1.7, install at least one easily
identifi able and accessible emergency command device
(emergency stop) in the vicinity of the gate, which may be
used to stop the gate in the event of danger.
WARNING!
Risk of injury when the gate is moving!
A moving gate can give rise to injury or damage in the gate
area.
►
Do not allow children to play on the gate system.
►
Ensure that no persons or objects are located within the
movement area of the gate.
►
In the event that the gate system is equipped with only one
safety device, operate the sliding opener only when you can
clearly see the movement area of the gate.
►
Monitor movement of the gate until it has reached its end
position.
►
Only pass or walk through gate openings of remote-
controlled gate systems if the gate is stationary!
►
Never stand within the open gate.
3.1
Safety instructions for installation, maintenance,
repair and disassembly of the gate system
The installation, maintenance, repair and disassembly of the
gate system and the sliding opener must be performed by expert
personnel.
►
In the event of the failure of the gate system or the sliding
opener (sluggishness or other faults), always commission
expert personnel immediately to inspect and repair the
system.
3.2
Safety instructions for installation
▪ The expert must ensure that the applicable regulations
concerning safety at work and rules on the operation of
electrical equipment must be observed during installation
work. To this end, the national guidelines must be followed.
Possible hazards per DIN EN 13241-1 can be avoided by
carrying out construction and installation in accordance with
our specifi cations.
▪ After completing installation, the installer of the gate must
declare conformity with DIN EN 13241-1 in accordance with
the scope of application.
▪
Before commencing electrical work, ensure that the
system is fully de-energised and secure it against
unauthorised re-activation.
Summary of Contents for CX1024
Page 1: ...www 4ddoors com au instructions for fitting operating and maintenance Sliding operator CX1024 ...
Page 2: ...2 A B Ø 12 mm Ø 5 5 mm 17 mm 3 mm 2 17 5 mm 3 mm PIC 01 ...
Page 12: ...ENGLISH 12 DX SX DX SX 11 Figure 11 End positions Max 38 mm 102 mm 12 Figure 12 Distances ...
Page 37: ...ENGLISH 37 ...