ENGLISH
25
7.28 Closing edge protection 2 (terminals J8/J9) input
This menu allows you to activate the closing edge protection type 2 input. The input is
only active in close direction.
nEin
The input is deactivated.
Input bridging is not necessary.
JA
The input is activated.
7.29 Evaluation of the closing edge protection
This menu allows you to set evaluation of the closing edge protection.
nEin
External evaluation with relay output (normally closed contact) without testing
8.2
The integrated 8k2 evaluation is activated.
rEL
External evaluation with relay output (normally closed contact) with testing
Note
nEin
Set if no closing edge protection is connected.
OK
OK
OK
Ï
Ï
Ð
Ð
7.30 Obstacle sensor in the open direction
This menu allows you to set the sensitivity of the obstacle sensor (current monitoring)
for the open direction.
• If the value "
nEin
" is selected, the obstacle sensor is deactivated.
• The higher the value, the more sensitive the control's response to an obstacle.
OK
OK
OK
Ï
Ï
Ð
Ð
7.31 Obstacle sensor in the close direction
This menu allows you to set the sensitivity of the obstacle sensor (current monitoring)
for the close direction.
• If the value "
nEin
" is selected, the obstacle sensor is deactivated.
• The higher the value, the more sensitive the control's response to an obstacle.
OK
OK
OK
Ï
Ï
Ï
Ð
Ð
Ð
OK
OK
OK
OK
Ï
Ï
Ï
Ï
Ð
Ð
Ð
Ð
Summary of Contents for CX1024
Page 1: ...www 4ddoors com au instructions for fitting operating and maintenance Sliding operator CX1024 ...
Page 2: ...2 A B Ø 12 mm Ø 5 5 mm 17 mm 3 mm 2 17 5 mm 3 mm PIC 01 ...
Page 12: ...ENGLISH 12 DX SX DX SX 11 Figure 11 End positions Max 38 mm 102 mm 12 Figure 12 Distances ...
Page 37: ...ENGLISH 37 ...
