ENGLISH
23
7.21 Warning light (terminals E4/E5) during the pause time
The warning light is usually actuated only when the gate is moving. If this function is
activated, the warning light also lights up when the gate is open or in an intermediate
position.
Note
This function is only possible if automatic gate closing is activated.
This function is deactivated in semi-automatic mode.
7.22 Command inputs (terminals J1/J4, J2/J4) function
This menu allows you to assign diff erent functions to the command inputs START and
START P.
StAn
Standard function of command inputs
START
and
START P
.
nEin
The control's command inputs are deactivated.
The radio receiver's inputs are active.
AU.ZU
The
START
input opens the gate.
The
START P
input closes the gate.
totb
totb function = person present: The gate opens if the
START
input is
actuated and closes if the
START P
input is actuated.
dAUF
Timer function: The gate opens and remains open until the continuous
open command at the
START
or
START P
input is opened.
The gate closes again once the hold-open and pre-warning times have
expired.
7.23 Stop input (terminals J3/J4)
This menu allows you to specify the functions of the stop input.
AUS
The STOP input is deactivated.
St.Gr
A STOP command stops gate movement. With the next START command, the
gate moves in the same direction.
St.Er
A STOP command stops gate movement. With the next START command, the
gate moves in the opposite direction.
Note
The parameters set here also determine the behaviour following a
START
command
following switch-off by an obstacle sensor or the closing edge protection. If the
function is deactivated, the gate moves in the same direction following a START
command.
OK
OK
OK
Ï
Ï
Ï
Ð
Ð
Ð
OK
OK
OK
OK
OK
OK
Ï
Ï
Ï
Ï
Ï
Ï
Ð
Ð
Ð
Ð
Ð
Ð
OK
OK
OK
OK
Ï
Ï
Ï
Ï
Ð
Ð
Ð
Ð
Summary of Contents for CX1024
Page 1: ...www 4ddoors com au instructions for fitting operating and maintenance Sliding operator CX1024 ...
Page 2: ...2 A B Ø 12 mm Ø 5 5 mm 17 mm 3 mm 2 17 5 mm 3 mm PIC 01 ...
Page 12: ...ENGLISH 12 DX SX DX SX 11 Figure 11 End positions Max 38 mm 102 mm 12 Figure 12 Distances ...
Page 37: ...ENGLISH 37 ...