UP/DOWN: Moves the elevator up/down by placing the cursor over the intended direction
and pressing and holding the left mouse button until the intended elevator placement is
achieved, or until the elevator reaches a direction limit.
53
m a n u a l o p e r a t i o n s
Set Start:
Saves the elevator’s current location as the Start position; the field to the right
displays the selected value for the Set Start position.
Note: This will not work if elevator has not been homed.
Set Offload:
Saves the elevator’s current location as the Offload position; the field to the right
displays the selected value for the Set Offload position.
Note: This will not work if elevator has not been homed.
Move:
Manually
moves elevator as the user specifies.
Distance:
Specifies distance, in inches or millimeters, from current position; negative moves
elevator down, positive moves elevator up.
Velocity:
Specifies the elevator speed in inches or millimeters per second during manual
motion; it does not affect motion during the move.
Stop:
Stops all motion during the move.
Action:
Describes the current elevator action.
Status:
Displays if the elevator has been reset by sending it to its
Home
location.
Clear Faults:
Attempts to clear all errors within the elevators system.
Stir:
System will move elevator up and down in a stirring motion. To achieve this: using the
move button, position the elevator to the upper most stir
position
, enter the down
Distance
of
the area to stir, enter the
Minutes
for the amount of time for the stir to transpire, and press
Stir
.
Note: These values apply only to manual movement.
Note: This will by ineffective if the build platform installed.
70696 Revision 1C 27-Aug-08
