3Com 3C63400-3AC-C - PathBuilder S700 Switch, Reference Manual

Page: 83 / 272

Performing Initial Configuration 69
To configure in-band management via the 10Base-T port on the near-end MCPU
card, follow these steps:
If you use this method, you must use a new subnet with each PathBuilder S700
and a new static route for each new subnet on the management station or router.
You are also limited to managing up to ten remote units from the central
management unit.
1 Build a PVC on the near-end PathBuilder S700 from the MCPU to the OC3 UNI,
setting the following parameters on the Add Virtual Circuit screen:
traffic shaper —Choose any of the available values (for example, 10Mbps).
IP address —This address must be different than the local host IP address.
subnet mask —Specify any acceptable address (for example, 255.255.255.0).
VPI/VCI —Enter any values in the accepted range (for example, 10/100).
2 Build a PVC on the far-end PathBuilder unit (S310, S330, S600, or S700) from the
MCPU to the OC3 UNI, setting the following parameters on the Add Virtual Circuit
screen:
traffic shaper —Choose any of the available values (for example 17M).
IP address —You must use a different subnet than the one you used for the
near-end PathBuilder S700.
subnet mask —Specify any acceptable address (for example, 255.255.255.0).
VPI/VCI —You must use the same values as you did for the near-end PathBuilder
S700.
3 From the System Administration menu, set the default gateway for the far-end
PathBuilder unit (S310, S330, S600, or S700) and the management station.
a Set the default gateway on the far-end PathBuilder unit to the PVC IP address
you set for the near-end PathBuilder S700 in step 1.
b Set the default gateway on the management station to the local host IP address
of the near-end PathBuilder S700.
For details about setting the default gateway, see “Configuring the Default
Gateway” earlier in this chapter.
4 Apply your IP configuration changes.
a From the main menu, select [1] System Administration .
b From the System Administration menu, select [3] Manage IP Network
Configuration .
c From the Manage IP Network Configuration menu, select [1] Local Host IP
Configuration .
d From the Local Host IP Configuration menu, select [3] Apply IP Configuration
Changes .