3Com 3036, Configuration Manual

Page: 652 / 762

648 C
HAPTER
45: C
ONFIGURING A
S
TANDBY
C
ENTER
main interface is a physical interface or sub-interface, use the following
commands in system view to enter the view of the interface.
Table 695 Enter the View of the Main Interface
If the main interface is a virtual circuit, it should be treated differently depending
on the type of the virtual circuit. First, specify its logic channel number in the view
of the physical interface to which it is subordinate, then enter the corresponding
logic channel view.
Use the following commands in the logical channel view.
Table 696 Enter the Logic Channel View
Specifying a Standby
Interface and the
Priority Used by the
Main Interface
Any physical interface or logic channel, including a virtual circuit or dialer route,
can work as a standby interface of the main interface.
Use the following commands in the view of the main interface.
Table 697 Specify Standby Interface and Priority Used by the Main Interface
If one main interface has multiple standby interfaces, repeat these operations. In
addition, if the standby interface is a logic channel, the logic channel should be
made to correspond to the actual virtual circuit or dialer route.
Please perform the following tasks in the views of the physical interface to which
the virtual circuit or the dialer route belongs, and specify the corresponding logic
channel number.
Table 698 Establish a Corresponding Relation Between Logic Channel and Virtual Circuit
or Dialer Route
Operation Command
Enter the view of the main interface
interface type number
Operation Command
Specify a logic channel number for an
X.25 virtual circuit. (interface view)
x25 map protocol address x121-address
x.121-address logic-channel number
Specify a logic channel number for a
frame relay virtual circuit (interface view)
fr map protocol address dlci dlci
logic-channel number
Specify a logic channel number for a dialer
route (interface view)
dialer route protocol
next-hop-address dialer-number
logic-channel number
Enter corresponding logic channel view.
(system view)
logic-channel number
Operation Command
Specify a physical interface to back up the
main interface; its priority can also be set
here.
standby interface type number [
priority ]
Specify a logic channel to back up the
main interface, its priority can also be set
here.
standby logic-channel number [
priority ]
Operation Command
Specify a logic channel number for X.25
virtual circuit
x25 map protocol address x121-address
x.121-address logic-channel number